Things used in this project
Before starting, the proper drivers must be installed to detect the COM ports. These drivers must be installed before downloading any codes from the codebender plugin. The drivers needed can be found here.
On the receiving end, a few modifications were made to the processor and motor board since only one battery was used. Headers were soldered onto the motor board where the motors and battery will plug into. On the processor, you can see that two wires have been soldered to the battery connector so that the motor board can receive power.
Assemble the stack, plug the power from the processor into the motor board, and plug the two motors into the motor 2 and 4 spots. You can solder the wires directly from the motors and processor to the motor board, we used headers to make things a bit more convenient if one of the motors were to break or we wanted to add an extra battery. Take your USB board and plug it into the top of the stack to charge your battery. Use the Robot_Control_Kit_Receiver code to program the receiver.
To setup the transmitter, all that is required is to upload the Robot_Control_Kit_Transmitter code. On the screen, the transmitter strength, receiver strength, packet delay, and voltage of the receiver will be displayed. Begin by turning on the receiver and then turn on the transmitter. If no connection is established, simply turn the transmitter off and on again.
No preview (download only).
Did you replicate this project? Share it!I made one
Love this project? Think it could be improved? Tell us what you think!